Hot Water Cyclinder (H.W.C)

This is the H.W.C I installed, it is mains pressure. I tyred to use less room as possible.

Roll over stack (modified), finished

This is the roll over stack that I have finished by my self. I was asked to install a tub going into a gully. The pipe supports were made out of spare sheet metal and all made by me, they were shown to me by my tutor, on how to make them. The W.C is centre. The p trap is going to a shower and the s trap is connected to the basin.

Roll over stack (modified), putting it together

Putting together a roll over stack (modified)

Installing a WC

This is a photo after I installed the WC. It was water tested and passed, it had no leaks. The WC was centre and sealed with neutral sealant.

Shower and Mixer

These are the shower and mixer I dismantled and installed again.

Taps

This are just some different taps I pulled apart and put together again.

Copper Joints

This is just my joint I made before I went on to taps

Copper Joints

These are just some of the copper joints I had made during the early stages of the course.